03-23-2008 12:03 PM - edited 03-15-2019 09:35 AM
Hi,
I have set up a small LAB for IPIPGW, i can go through it with G711 but when i begin to manipulate the codec, like using using G729 it does not work.
what i need to do:
1) CCM 1 (G711) IPIPGW (G729) CCM2;
I have transcoding for CCM1, CCM2 and for the IPIPGW running but no luck
2) CCM1 104 calls CCM2 7002 get a busy tone when off hook.
I donno what i am missing???
Good day
03-23-2008 12:14 PM
Could you please upload
debug voice ccapi ino
debug h225 asn1
debug h225 q931
debug h245 asn1
Please?
03-23-2008 12:27 PM
Hi,
attached are the debugs. i have noticed something during my tests as follow
CCM1 (G711) icoming Dial-Peer IPIPGW (G711)
Outgoing DIal-Peer IPIPGW (G729) CCM1 (G729) this combination works
and i see transcoding done by the IPIPGW from G729 to G711. Why i cannot make CCM1 (ICT as G711)!!!
Good day
03-23-2008 12:33 PM
CCM1 (G711) icoming Dial-Peer IPIPGW (G711)
Outgoing DIal-Peer IPIPGW (G729) CCM2 (G729) this combination works
and i see transcoding done by the IPIPGW from G729 to G711. Why i cannot make CCM2 (ICT as G711)!!!
Sorry it should be CCM2. The other annoying part as well is that when G729 in CCM2 i cannot use the hold, transfer, etc... please note that the MTP is checked for both ICT Non GK controlled.
Good day
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: