Debugging/error messages

Unanswered Question
Mar 23rd, 2008
User Badges:

I'm having trouble getting a laptop to authenticate and I was hoping someone could help me with what debug commands to use on the AP. I've tried a few but I'm not getting anything to show up at the console prompt on the AP. I'm running Windows 2003/IAS/RADIUS with a single AIR-AP1232AG-A-K9. Everything is setup for PEAP (EAP-MSCHAP V2). Any help would be greatly apprecaited. Thanks.


Riley

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
irisrios Fri, 03/28/2008 - 09:21
User Badges:
  • Silver, 250 points or more

Enable the command terminal monitor from the previliege mode and then use the debug commands on the access point.

rileymartin Fri, 03/28/2008 - 16:34
User Badges:

Thanks for the reply.


I'm new to both Cisco and wireless so I'm not sure exactly what debug commands would be best. I'm not familiar with everything involved in troubleshooting problems with connections/associations and authentications and the radios etc. Would you mind recommending which commands I should use and for what purpose? Thanks.

Scott Fella Fri, 03/28/2008 - 18:00
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Post the errors you see on the IAS serever event viewer. Also post the show log from the AP... just so we can see the errors.


Here is a link to some of the debug commands:


http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/command/reference/cr12410b-chap2.html

Actions

This Discussion