Input errors on 4507 gigE port connected to Meru Controlelr

Unanswered Question
Mar 24th, 2008

I have a couple of Meru Controllers. One for onsites and one for Off-sites. Both are plugged into the same 4507 switch into different gigE ports. The on-site controller continues to show input errors on the switch interface while the off-sites controller does not. Both ports are configured the same and as far as I can tell the controllers are configured the same.

Any thoughts? Attached is a show interface on the 2 controller ports.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion