cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1157
Views
0
Helpful
1
Replies

DTMF Relay problem over SIP trunk and CUBE to Cisco Unity

justincohen
Level 1
Level 1

I'm running a SIP provider trunk into a CUBE setup (IPIPGW IOS) to a CUCM 6.1

All is working except when users end up in Unity Connection any DTMF's they press are followed by Unity stating "I did not recognize that as a valid entry"

The exact same handler dialer internally works fine... Even the trace from the gateway is fine...

Dial-Peers are as follows....

dial-peer voice 6112 voip

description inbound leg from SIPProvider

rtp payload-type nte 120

session protocol sipv2

incoming called-number 6112

dtmf-relay rtp-nte

codec g711ulaw

fax rate disable

!

dial-peer voice 7112 voip

description Outbound Leg to CUCM

destination-pattern 6112

session target ipv4:192.168.2.102

dtmf-relay h245-alphanumeric

codec g711ulaw

fax rate disable

no vad

And the H245 even sends the right stuff, did I miss something?

.Mar 24 19:12:57.006: h245_encode_userInputIndicaiton_indication

.Mar 24 19:12:57.006: h245_encode_user_input_indication: 2

1 Reply 1

bwilmoth
Level 5
Level 5

Configure the DSP resources to be able to do in-band conversion for dtmf.

Also refer this bug id for more information on DTMF issue with SIP trunks:CSCse27247

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: