03-25-2008 06:08 AM - edited 03-05-2019 09:57 PM
Help Please. I have a router 2650, when I turn on, it is showing (see below)
loadprog: bad file 0x0
load: cannot load "flash"
How do I break into this router? I am using windows XP with hyper termianl with default setting 9600. Thanks,
03-25-2008 06:33 AM
You need to connect your console cable to the router and open your Hyperterminal session.
When you switch the router on, hit "CTRL-BREAK" several times; keep doing it until it shows you the "rommon 1>" prompt.
From there, you should be able to reconfigure the router to use the correct IOS image, or install a new IOS image if the old one is corrupt.
Hope this helps!
Graeme
03-25-2008 08:09 AM
It is still show the same error:
loadprog: bad file magic number: 0x0
boot: cannot load "flash"
Here is what I did.
===================
I disconnect HT
Reconnect HT
Hold down CTRL key
Turn router power on
Press Break key
Other solution please. Thanks,
03-25-2008 01:38 PM
See:
for instructions on how to load a new IOS image.
03-25-2008 01:47 PM
I have gone to this site, but rightnow. My router is still boot with infinity loop. I can not get to this rommon 1>. I wish I would but still do looping over and over. Help please.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: