Slow response after power outage

Unanswered Question
Mar 25th, 2008

G'day all

We had power outage and ever since I'm getting terrible network responce from a numnber of our IBM servers that run broadcom network team. Is there any issues that are known or what shoukd I start looking at to try and solve the issue.

The network cards are set to auto speed (1g) and the network ports are as follows

interface GigabitEthernet6/43

switchport access vlan 10

switchport mode access

switchport nonegotiate

speed 1000

duplex full

spanning-tree portfast

spanning-tree guard root

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 1 (1 ratings)
glen.grant Tue, 03/25/2008 - 19:58

Leave the switchports as auto also if the nics are auto this could be causing a problem , you always match each side.

clubsprint Tue, 03/25/2008 - 20:07

I've found it is usually better to hard set one side at least. I've moved the connection to another port on another card and that' OK so it looks like I might have a faulty card. I'm not sure how to diagnose this though.


This Discussion