03-26-2008 02:39 AM - edited 03-03-2019 09:16 PM
Dear All,
Could you tell me please, i have router cisco 1841 and Module card Hwic-1FE.when plug Hwic-1FE to router and i type command show run i don't see interface Hwic-1FE on Router 1841.What is going on ?
Note:i used this IOS : c1841-ipbase-mz.124-1c.bin
Best Regards,
Rechard
03-26-2008 03:00 AM
You need a later IOS for that card, I recommend 12.4(11)XJ4.
If you don't have the support contract required to download the image from CCO, either buy a service contract or ask who has sold you router/card to provide it to you.
Hope this helps, please rate post if it does!
03-26-2008 06:18 PM
Dear sir,
Thank you for your advices!!!
Ok i understood. Could you give more detail part number that can support command load balancing.
one more when i plug card to the router are three LEDs port is up(mean light is on are three port are up)
Note: i not yet plug network cable to module card.
Best Regards,
Rechard
03-26-2008 06:26 PM
No part numbers. Load balancing is embedded in IOS and just a matter of configuration.
As a recognition to those providing answers, please rate useful posts with the scrollbox below!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: