03-26-2008 06:20 AM - edited 03-15-2019 09:39 AM
Hi,
I have configured CME 4.1 to act as SIP Proxy Server,Configured it corectly so X-Lite SIP Softphone can register with it. Inside LAN network X-Lite to X-Lite calls function without the problem, but:
I connect through VPN to my LAN and register X-Lite with CME (extenssion 66) without any problem.
The other person also connects to our LAN through and registers his X-Lite with CME (extenssion 55).I would like them to talk to each other.
The problem is following. When any of us try to call eachother, the X-Lite Rings, and when a call is answered it immediatly drops with error "Internal Server Error". This is SIP 500 message.
Does anybody has a clue why is this happening and how it can be solved.
regards,
Solved! Go to Solution.
03-26-2008 08:43 AM
Call from 2222 tries to use an unsupported speex codec. Please configure x-lite to use g711u only.
03-26-2008 07:27 AM
Have configured codec g711u for the voice pool
03-26-2008 07:31 AM
yes, I have configured it with the command
voice class codec 1
codec preference 1 g711alaw
codec preference 2 g711ulaw
and then under voice poolvalso
voice-class codec 1
03-26-2008 07:38 AM
Are both phones registered to CME ?
Can you include the full "debug ccsip message" ?
03-26-2008 07:41 AM
Yes,both phones are registered to CME through VPN.
03-26-2008 07:39 AM
I have also to mention following.
When I connect from one location using VPN and registering to CME with IP Communicator and from other Location using VPN and registering X-Lite, calls can be placed between IP Communicator and X-Lite.
The only issue is X-Lite to X-Lite (SIP to SIP) calls
regards
03-26-2008 07:44 AM
Should not be necessary, but please also configure
voice service voip
allow-connections sip-to-sip
03-26-2008 07:49 AM
have already configured that.
03-26-2008 07:55 AM
Please send the complete trace.
03-26-2008 07:57 AM
Ok,
I will send it soon
03-26-2008 08:36 AM
03-26-2008 08:43 AM
Call from 2222 tries to use an unsupported speex codec. Please configure x-lite to use g711u only.
03-26-2008 12:23 PM
Hi,
In X-Lite I have set only G711a and G711u codecs, but it was not working.
When I set only G711u codec it worked.
Thanx very much
I will grade it with 5 ;-)
regards
03-26-2008 01:24 PM
Great, thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: