inspect ftp on 5520

gmtimmons · ‎03-26-2008

configuring my new 5520 and ran the output interperte on it. states : WARNING: FTP inspection engine is disabled. Outbound users will be able to start

connections only in passive mode, and all inbound FTP will be disabled.

TRY THIS: Enable FTP inspection engine using the 'inspect ftp' command in class

configuration mode

im sure this isnt complicated, but some of the commands I found on cisco site arent working..... please advise

thanks

i-kendall · ‎04-01-2008

Near the very bottom of the config, it should have the following

policy-map global_policy

class inspection_default

inspect ftp

If the inspect command is not present, and your question implies it is not, then add these three lines in config mode, and it should be fixed.

If not, then post the config, and I will take another look.

Regards,

Iain