use pat on outside interface

Unanswered Question
Mar 26th, 2008
User Badges:

apparently I have a global range defined on my outside interface, suggestion is to use a pat statement to replace this. looking for guidance

thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
husycisco Wed, 03/26/2008 - 13:43
User Badges:
  • Gold, 750 points or more

Hi Mark

All you have to do is defining 1 single IP entry or the interface itself in the following section

global (outside) x ipaddresshere or

global (outside) x interface


gmtimmons Fri, 03/28/2008 - 06:59
User Badges:

so basicaly a

global (outside) id ousideip.2-outsideip.7 netmask x.x.x.x can be replaced with

global (outside) id outsideip.2


husycisco Fri, 03/28/2008 - 08:00
User Badges:
  • Gold, 750 points or more

Exactly. If it fails, try

global (outside) id outsideip.2 netmask

smohanasundaram Fri, 05/02/2008 - 02:48
User Badges:


try with this config

for Example

nat (inside) 1

global (outside) 1 "outside Ip"

hopes this helps


S.Mohana sundaram


This Discussion