isdn error msg on cisco 2811 w/ voip card..vwic

Unanswered Question
Mar 26th, 2008
User Badges:

hi guys, i have configured the 2811 with a pri-group,dial-peer,destination........(10 digits..2811 is connected to a voice server/isdn-pri which originates the call and passes it on to the 2811, my target ip is 192.168.x.x,which is a multitech(voip gateway)already in my network connected to a juniper..


Problem:I get an error msg:Cause i = 0x82A6 - Network out of order...

I can ping the 2811 from the multitech, but cannot ping the multitech from the 2811....any ideas, do i have to define any type of route in the cisco2811.

***************************************

CIA2811_UK-VOIP#deb isdn q931

debug isdn q931 is ON.

CIA2811_UK-VOIP#

000437: *Mar 26 12:15:55.431 PCTime: ISDN Se0/1/0:23 Q931: RX <- SETUP pd = 8 callref = 0x0008

Bearer Capability i = 0x8090

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xE9808381

Exclusive, Interface 0, Channel 1

Net Specific Fac i = 0x00E3

Calling Party Number i = 0x2180, '9933000'

Plan:ISDN, Type:National

Calling Party SubAddr i = 0x80, 'P123'

Called Party Number i = 0xA1, '9734390088'

Plan:ISDN, Type:National

Called Party SubAddr i = 0x80, 'P456'

Plan:Unknown, Type:Unknown

000438: *Mar 26 12:15:55.451 PCTime: ISDN Se0/1/0:23 Q931: TX -> CALL_PROC pd = 8 callref = 0x8008

Channel ID i = 0xA98381

Exclusive, Channel 1

000439: *Mar 26 12:15:55.459 PCTime: ISDN Se0/1/0:23 Q931: TX -> DISCONNECT pd = 8 callref = 0x8008

Cause i = 0x82A6 - Network out of order

000440: *Mar 26 12:15:55.471 PCTime: ISDN Se0/1/0:23 Q931: RX <- RELEASE pd = 8 callref = 0x0008

Cause i = 0x80A6 - Network out of order

000441: *Mar 26 12:15:55.475 PCTime: ISDN Se0/1/0:23 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x8008





  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Wed, 03/26/2008 - 15:03
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi since we can't know your network topology, you need to revise it until you can ping anything from everywhere. Then things will work.


Separately, I would be curious to know how you can generate a call with subaddress "P456".

Actions

This Discussion