03-26-2008 11:46 AM - edited 03-11-2019 05:22 AM
Hey all
two pix 525s. One on each side of a t1.
Set up looks like this:
Pix---Router---T1---Router---Pix
One of the routers is set up with a private address on the inside (which then connects to a pix on a private address).
How do I get that pix to set up a tunnel?
(I have done many tunnels when both sides are public IPs)...I just don't know how to traverse the nat.
03-26-2008 11:58 AM
Are these your routers? or are they managed by someone else?
03-26-2008 12:01 PM
they are mine.
Lets try with this example:
Router Outside: 4.1.1.1
router Inside: 10.1.1.1
Pix Outside 10.1.1.2
pix Inside: 192.168.1.1
03-26-2008 12:10 PM
This should help you out:
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094ecd.shtml
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: