cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
593
Views
3
Helpful
3
Replies

FXO And Unity Voicemail - disconnect issue

cplatt01
Level 1
Level 1

I have a site where a standard POTS line is connected to a 2851 router FXO port. This is an MGCP gateway.

The problem I have is that when I call the number (10 digit) and leave a voice mail, about 10 seconds later the phone rings from an unknown number.

Troubleshooting steps taken:

1) I thought it may be an FXO disconnect problem. Changed port to ground start

2) Disabled supervisory disconnect

After attempting both of these, the issue is still happening. Any advice is greatly appreciated.

1 Accepted Solution
3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Hi, unless telco changes to ground start too (that is used only in the US), that has no effect. So you will need to configure tone based disconnect supervision, there's is no alternative.

I was afraid of that....best way to do tone based disconnect?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: