03-27-2008 12:51 AM - edited 03-05-2019 10:00 PM
Hi!
I would save resualt show tech from my Cisco 6006. As we know the output of the command "show tech" is very lang. How can I save the output from the this command in easy way? Tnaks in advance.
/Sfanayei
03-27-2008 12:58 AM
Hi
I usually do it with windows Hyperterm. Log into the switch and
1) IOS - switch# term len 0
Cat0S - switch# set len 0
This will ensure that when you run the command "sh tech..." it will not pause at the end of each screen.
2) In hyperterm along the menu at the top select
Transfer -> Capture Text
You will then be prompted as to where to save the file that will capture the text.
3) Run your command
4) Go back to Transfer -> Capture Text and stop the capture.
HTH
Jon
03-27-2008 01:37 AM
Dear Jon!
It was very useful. I got it. Tanks again
/Sfanayei
03-27-2008 01:37 AM
Not sure about catos but with IOS, the terminal length seems to be set by its own when we issue the sh tech-support command. ( I never had to press space :-) )
Narayan
03-27-2008 01:40 AM
Narayan
Thanks again. I use the above primarily for getting a "sh run" so i'm so used to setting the term length. I'm thinking maybe i should retire for the day and let you take over because you are definitely more on the ball this morning :).
About time i rated you
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: