03-27-2008 08:08 AM - edited 03-03-2019 09:18 PM
Dear all,
If the router see the route A in the routing table, it will static nat host A to X, if route A is not present, router will static nat host B to X.
Thanks,
03-27-2008 10:47 AM
You can use EEM to dynamical change router configuration based on events:
Hope this helps, please rate post if it does!
03-27-2008 11:26 PM
Looks like a very neat feature.. I didn't knew it was possible with the ISR series
This could help us remove the Radware device and have dynamic NAT changes to different provider address space based on some events
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: