Cisco 4404 WLC

Unanswered Question
Mar 27th, 2008

I want to etherchannel my Cisco 4404 to my Catalyst 6513. I create the etherchannel on my 6513, but was wondering how I create my etherchannel on my Cisco 4404? The commands are not the same as my Catalyst 6513. Any guidance would be appreciated.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Thu, 03/27/2008 - 12:55

You need to go to the General tab on your 4404 GUI and set LAG to enable. Also make sure you configure your etherchannel to channel-mode on and that etherchannel load balance is configured to scr-dst-ip.

Actions

This Discussion