cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
342
Views
0
Helpful
1
Replies

Configuring Live-Record, getting busy signal

cschear
Level 1
Level 1

I am following this URL as a configuration reference:

http://www.cisco.com/en/US/docs/voice_ip_comm/unity_exp/rel3_1/administration/guide/voicemail/12advVM.html#wp1016471

I have configured an extension in my CME that CFA to my Live-Record pilot number. Configuration below:

--------------------

ephone-dn 143

number 2600

label Live Record

description Live Record

name Live Record

call-forward all 2601

--------------------

I have configured 2601 as my Live-Record Pilot number:

--------------------

voicemail live-record beep duration 0

voicemail live-record pilot-number 2601

--------------------

When I "show voicemail live-record", I can see it is enabled.

rt-cme-unity# show voicemail live-record

Status: enabled

Pilot number: 2601

Conversation beep settings

Beep Duration: disabled

Beep Interval: 15 seconds

--

When I am talking to another CME extension, I attempt to conference in "2600" and get a busy signal. The URL I am referencing state a possible error condition is:

The following error conditions can occur for subscribers using live-record:

•No Ports Available - Busy tone plays to the caller

As I am receiving a busy tone, I suspect this is my "error". But, I'm not certain why I would have no ports available. My CME only has 3 users configured on it, and the two people trying to use the LiveRecord are the ONLY users actively using the phone(s) at the time.

What am I missing here?

1 Reply 1

cschear
Level 1
Level 1

I should also state, when I attempt to conference in "2600", my display on my IP Phone indicates, "Unknown number".

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: