Configuring a Frame-Relay CIR

Unanswered Question
Mar 27th, 2008
User Badges:

Hi,


I'm currently a student in CCNP and in my troubleshooting class we have to configure a CIR of 256kb over a frame-relay link. The topology is a strandard triangular shaped 3-router mesh. 2 PVCs, the central router has a multipoint sub interface while the two others are P2P. this is what I configured:


map-class frame-relay CIRMAP

frame-relay cir in 256000

frame-relay cir out 256000


on the interface:

frame-relay map CIRMAP


then I use the command:

show frame-relay pvc X

Only half the usual output appears and nothing is mentionned relating to the CIR.


What am I doing wrong?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Edison Ortiz Thu, 03/27/2008 - 17:17
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

You need to enable traffic-shaping.


On the hub's main interface enter the following command:


frame-relay traffic-shaping

and under the subinterface

frame-relay interface-dlci [dlci]

class CIRMAP.


Then, you can do the show frame-relay pvc X command.


HTH,


__


Edison.

Actions

This Discussion