Hi,
I'm currently a student in CCNP and in my troubleshooting class we have to configure a CIR of 256kb over a frame-relay link. The topology is a strandard triangular shaped 3-router mesh. 2 PVCs, the central router has a multipoint sub interface while the two others are P2P. this is what I configured:
map-class frame-relay CIRMAP
frame-relay cir in 256000
frame-relay cir out 256000
on the interface:
frame-relay map CIRMAP
then I use the command:
show frame-relay pvc X
Only half the usual output appears and nothing is mentionned relating to the CIR.
What am I doing wrong?