DHCP not working on new AP521G

Unanswered Question

We have a brand new AP521G (the stand-alone one) and when we connect it to an Ethernet port it does not seem to attempt to get an address from either of our Windows DHCP servers. As a result we cannot connect to configure it with the CCA. This new AP is connected directly to a working port that connects directly to the same switch that one of the DHCP servers is on. Anyone have any ideas? Thanks...

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
irisrios Thu, 04/03/2008 - 11:19

Check if you are able to ping the DHCP server and the access point. Check if the DHCP is configured right to assign the ip addresses to the clients from access point.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode