03-29-2008 02:26 AM - edited 03-15-2019 09:43 AM
Hi,
I am having a very weird problem on E1-pri card on NM-1CE1T1-PRI module.
After I configured the pri-group timeslots 1-31,16...I noticed the associated voice-port 1/0:15 was not created. Interface serial 1/0:15 was created.
When I do a sh ip int br...The ints1/0:15 status shows reset....
as shown below:
Serial1/0:0 unassigned YES unset reset down
Serial1/0:1 unassigned YES unset reset down
Serial1/0:2 unassigned YES unset reset down
Serial1/0:3 unassigned YES unset reset down
Serial1/0:4 unassigned YES unset reset down
Serial1/0:5 unassigned YES unset reset down
Serial1/0:6 unassigned YES unset reset down
Serial1/0:7 unassigned YES unset reset down
Serial1/0:15 unassigned YES unset reset down
My config looks like this...
card type e1 1
network-clock-participate slot 1
!
isdn switch-type primary-net5
Controller e1 1/0
pri-group timeslots 1-31,16
interface Serial1/0:15
encapsulation hdlc
no ip address
isdn switch-type primary-net5
isdn incoming-voice voice
no cdp enable
Solved! Go to Solution.
03-29-2008 03:01 AM
NM-1CE1T1-PRI does not support voice.
Hope this helps, please rate post if it does!
03-29-2008 03:01 AM
NM-1CE1T1-PRI does not support voice.
Hope this helps, please rate post if it does!
03-29-2008 04:33 AM
Thank you!!!!!!!!
03-29-2008 11:10 AM
You're welcome. Thanks for the nice rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: