DSL Modem in Bridge Mode

Answered Question
Mar 29th, 2008
User Badges:

First off , when I use the word "work or worked" Im reffering to being able to get out on the internet.


Recently I was able to make an Embarq DSL modem work with a cisco router behind it. The modem however was NOT in bridge mode.


Now I want to make this work with the Modem in "bridge" mode. I have the Modem currently in bridge mode but I am unsure of the simplest way to setup NAT. Could someone look at this and reccomened a simple NAT config:

MODEM - Bridge Mode

WAN - fa0/0 67.234.34.76/18

LAN - fa0/1 192.168.1.1 255.255.255.0

LAN - 192.168.1.10 - 192.168.1.254


DHCP gives IPs to clients on LAN


Correct Answer by paolo bevilacqua about 9 years 3 months ago

If "worked", why not rate the post ?

A concise and effective config example also suggesting how to check on things. My rating, a '5'.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
i-kendall Sun, 03/30/2008 - 02:50
User Badges:

Here you go. It assumes you also have a default route to the Internet.


interface fastEthernet0/0

ip nat outside

interface fastEthernet0/1

ip nat inside


ip nat inside source list 10 interface ethernet0/0 overload


access-list 10 permit 192.168.1.0 0.0.0.255


Any LAN ip that tries to go to the Internet will have it's source ip translated to the same as the WAN interface ip. You can look at a show ip nat trans command to see this has happened.


Hope this helps.

Correct Answer
paolo bevilacqua Sun, 03/30/2008 - 15:49
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

If "worked", why not rate the post ?

A concise and effective config example also suggesting how to check on things. My rating, a '5'.

Actions

This Discussion