PRI / Ethernet config

Unanswered Question
Mar 30th, 2008

Hi there,

I am looking to create a configuration to connect two PABX systems both with an PRI module in it via Cisco routers (with also VWIC-E1/T1 modules in it) over ethernet to eachother. So the PABX systems can communicate with eachother. Can somebody give me a clue where to start ? I looked on the Cisco site but really cannot find the right configuration documents.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mamkreutz01 Sun, 03/30/2008 - 22:32

Hi there,

The two PABX systems are not VoIP as far as i know. They are only equipped with PRI modules (E1). Do the dial-peers need to be entered at the Cisco routers then or at the PABX systems ?

Avner Izhar Sun, 03/30/2008 - 23:16

In the routers, everything I referred to is configured in the routers.

HTH, Avner.


This Discussion