03-30-2008 05:48 AM - edited 03-15-2019 09:44 AM
Hi there,
I am looking to create a configuration to connect two PABX systems both with an PRI module in it via Cisco routers (with also VWIC-E1/T1 modules in it) over ethernet to eachother. So the PABX systems can communicate with eachother. Can somebody give me a clue where to start ? I looked on the Cisco site but really cannot find the right configuration documents.
03-30-2008 10:20 PM
Try this link for general knowledge:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00807f54aa.shtml
Generally you would need to:
- config ip addresses on your Ethernet interfaces, make sure they can ping each other.
- Set the controllers and the voice ports.
- Set dial-peers.
The routers will need voice dsp in it.
HTH, Avner.
03-30-2008 10:32 PM
Hi there,
The two PABX systems are not VoIP as far as i know. They are only equipped with PRI modules (E1). Do the dial-peers need to be entered at the Cisco routers then or at the PABX systems ?
03-30-2008 11:16 PM
In the routers, everything I referred to is configured in the routers.
HTH, Avner.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: