ISDN

Unanswered Question
Mar 30th, 2008
User Badges:

Hello


I already interliguei cisco voice gateway with Philips and Avaya PABX by ISDN QSIG. In both, the name called was not transmitted. I saw some papers and discussions here in netpro with professionals with the same diagnosis. But if I connect two PABX Siemens by ISDN QSIG this information now. If I connect two PABX Philips also. Siemens has a protocol called T-QSIG which is the QSIG changed. Philips I know but should use something like that. My question is: If I interconnect 2 cisco voice gateway by ISDN QSIG (even knowing that other interconnections would be best, but as a curiosity), the name would be called shared?


Thanks


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.5 (2 ratings)
Loading.
paolo bevilacqua Sun, 03/30/2008 - 16:17
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

If you these are GWs for CM with MGCP, name support depends by the qsig settings in gw configuration page.


Else configure "voice service voip - qsig decode" and name will be supported.


Hope this helps, please rate post if it does!

pgcristovam Sun, 03/30/2008 - 16:25
User Badges:

Hi


"voice service voip - qsig decode", only between Cisco GW or between GW and PABX another vendor too?


Thanks


paolo bevilacqua Sun, 03/30/2008 - 23:49
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Works with anyone.

Boa interligacao!

Actions

This Discussion