CLI presentation issue

Unanswered Question
Mar 31st, 2008

Hi all,

Got a bit of a confusing issue with CLI presentation on our lines. Here's a bit of config from the 2821 acting as a H323 gateway:

dial-peer voice 1 pots

destination-pattern T

<snip>

translate-outgoing calling 1

<snip>

port 0/0/0:15

forward-digits all

voice translation-rule 1

rule 1 /^62\(.*\)/ /012345678\1/

Real DDI hidden of course! :)

I'm using cucm 4.1(3)sr4d with a local sub on the same subnet as the gateway. RL/route pattern/gateway/etc are set to "default" on cli presentation settings.

When I test the voice translation rule above on the voice gateway, it successfully translates the 4 digit extension back to the full DDI.

When I make an outgoing call from 6290 it comes up with the first DDI on the E1 trunk, instead of matching the last two digits, eg:

01234 567800

When I'm expecting:

01234 567890

I'm not sure where I'm going wrong! If I could get some tips I would really appreciate it, TIA.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion