WLC AND AIRONET 1240 LWAPP CONFIG

Unanswered Question
Mar 31st, 2008

Hi all, Can anyone tell me what I need to do to configure my 1240ag access points to work with my wlc using lwapp.

Also how reliable are the wlc's should you use a backup wlc on each site ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Mon, 03/31/2008 - 10:37

Your 1240ag must be an LWAP. Look at the back of the AP and check the model. If you see AP1242 then no, but if you see LAP1242 then all you need to do is stage the LWAP to the WLC.

Backups depend on your policies and how important the wireless will be to your byusiness.

Read this doc to help you understand better. Hope this helps:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_example09186a0080665cdf.shtml

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode