On my LMS 3.0 under the Best Practices Deviations i got the following message:
BPDU-Guard disabled on access ports
When i check the config of the according switch i see that bpdu-gard is enabled by default.
spanning-tree mode pvst
spanning-tree portfast default
spanning-tree portfast bpduguard default
spanning-tree portfast bpdufilter default
switchport access vlan 27
switchport mode access
no ip address
no logging event link-status
no snmp trap link-status
no cdp enable
Can anyone explain to me, why LMS tells me to configure bpdu-guard on every interface seperately?
thanks a lot!
We stopped looking at the Physical Discrepancy and Logical Discrepancy reports produced by Campus Manager since LMS 2.2 because of this issue. The bottom line is LMS is just not sophisticated enough to know all the assorted configuration possibilities. So LMS ends up producing these false-positives unless it sees the switches are configured only the way it deems "correctly"--apparently per-interface BPDU guard in this instance. In short, simply ignore it.