Solved: Dial-Peer problem

UCcomp2007 · ‎04-01-2008

I have a basic international dial-peer (destination-pattern 011T). I am prefixing 011. For testing I have a CME running and have the PRI setup. I see on the CME that 011 is not being sent over. I have no forward-digit command in this dial-peer.

Has any one seen an issue with 011 not getting prefixed (even though it's in the statement)?

Thanks

paolo bevilacqua · ‎04-01-2008

Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.

Hope this helps, please rate post if it does!

View solution in original post

paolo bevilacqua · ‎04-01-2008

Please configure "forward-digits all" or "no strip-digits". With these commands, no prefix command is necessary.

Hope this helps, please rate post if it does!