04-01-2008 02:05 PM - edited 02-21-2020 10:20 AM
folks
i have a ACS 1113 appliance which i'm trying to hyperterminal to but with no joy
i'm using
115200
8
N
1
No flow control
but i can't get anything from the console
i have tried the same on my backup box but still the same
does anyone know the actual settings
thanks to anyone taking the time to reply
04-07-2008 10:54 AM
change the console cables. also give the proper console parameter for the console session with the box
04-07-2008 11:44 AM
i resolved the the problem along the lines of your suggestion
i use both juniper and cisco kit but i had got the db9 plugs mixed up
when i made sure the console cable had a db9 from the acs1113 box it all worked
must have been an issue with pin outs
many thanks for taking the time to reply
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: