Link-type parameter gigabitethernet

Unanswered Question
Apr 1st, 2008

I need information on the parameter link-type independent of the information of spanning-tree, I am doing a research on how important this is a parameter interface.

GigabitEthernet1/0/1 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet, address is 001f.26c7.1701 (bia 001f.26c7.1701)

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive not set

Full-duplex, 100Mb/s, ****link type is auto****, media type is 10/100/1000BaseTX SFP

all type information is good.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion