cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
695
Views
10
Helpful
7
Replies

1801 with two internet connection

yaniv
Level 1
Level 1

Hi,

I need to configure 1801 with the following requirement:

1. one link to isp1 with adsl line

2. one link to isp2 with cable line

3. to cut the lan ports to few vlans

4. to route each vlan via different isp

5. to make QoS to keep amount of bandwidth to video application

6. I don't need BGP cause its doesn't do load balance

Do you think it's possible?

Do you think it will handle it?

Thanks

1 Accepted Solution

Accepted Solutions

Hi yaniv,

First of all, It's possible.

As per your requirement,I would think about Policy-Base routing to help you out.

Just let some vlans to go ISP_1 and others to go ISP_2.One thing I would very carefully think about NAT as well when you want to do this.

Hi poalo , Seems you are in a rush to get a fantastic star!! 5 points from mind.

Hopes this helps

Thot

View solution in original post

7 Replies 7

paolo bevilacqua
Hall of Fame
Hall of Fame

Yes, it's possible:

Note for 6, BGP does load-balancing. The real issue is that is complicated and expensive to obtain, setup, and maintain.

Hope this helps, please rate post if it does!

Thanks a lot

You're welcome. Please remember to rate useful posts with the scrollbox below!

Hi yaniv,

First of all, It's possible.

As per your requirement,I would think about Policy-Base routing to help you out.

Just let some vlans to go ISP_1 and others to go ISP_2.One thing I would very carefully think about NAT as well when you want to do this.

Hi poalo , Seems you are in a rush to get a fantastic star!! 5 points from mind.

Hopes this helps

Thot

Hi again,

I did some work

I hope I am not a trouble but I need to here your advise

Thanks again

Hi again,

I did some work

I hope I am not a trouble but I need to here your advise

Thanks again

Hi, I haven't checked the full config, seems to me you're in the right direction, I would use two separate ACL for the source IPs, and in the route-map no match for interface, rather use "set default".

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: