CatOS convert to IOS Catalyst 4506 with Sup 2

ney25 · ‎04-02-2008

Hi NetPro,

Currently, my access switch using 4506 n Sup2, running on CatOS . so, would it be possibled to convert to IOS ?

here with the hardware spec.

WS-C4506 Software, Version NmpSW: 8.4(7)GLX

NMP S/W compiled on May 9 2005, 18:26:07

GSP S/W compiled on May 09 2005, 17:31:33

System Bootstrap Version: 5.4(1)

Hardware Version: 5.0 Model: WS-C4506 Serial #: FOX06481MCT

Mod Port Model Serial # Versions

--- ---- ------------------ -------------------- ---------------------------------

1 2 WS-X4013 JAE06460452 Hw : 5.0

Gsp: 8.4(7.0)

Nmp: 8.4(7)GLX

4 48 WS-X4148-RJ JAE063807GC Hw : 3.1

DRAM FLASH NVRAM

Module Total Used Free Total Used Free Total Used Free

------ ------- ------- ------- ------- ------- ------- ----- ----- -----

1 65536K 40206K 25330K 16384K 10214K 6170K 480K 317K 163K

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X4013 no ok

4 4 48 10/100BaseTx Ethernet WS-X4148-RJ no ok

Mod Module-Name Serial-Num

--- -------------------- --------------------

1 JAE06460452

4 JAE063807GC

Mod MAC-Address(es) Hw Fw Sw

--- -------------------------------------- ------ ---------- -----------------

1 00-0b-5f-ec-34-00 to 00-0b-5f-ec-34-3f 5.0 5.4(1) 8.4(7)GLX

4 00-0a-f4-54-65-90 to 00-0a-f4-54-65-bf 3.1

your reply will be highly appreciated.

thanks.

regards,

Jack

jcoke · ‎04-02-2008

Nope, the Sup II is CatOS only. Your only option is to upgrade to a Sup II+ (or greater of course) You should double check that all your line cards are supported before you do.

ney25 · ‎04-03-2008

Hi,

thanks for your information.

regards,

Jack