04-02-2008 07:53 AM - edited 03-15-2019 09:48 AM
Hello!
I've issue at Cisco ISR 2811 CCME 4.1 with AIM-CUE (ver 3.0.3). I have script where possible to dial-by-extension. When I'm dialing by existing extension - all ok, but when dialed invalid extension number I hear silence. When IP Phone is busy - CUE can't understand that and I hear silence too.
I had test that script for invalid numbers and busy with CUCM 6.1, script worked fine.
Could you tell me plz, whats going on?
04-02-2008 08:09 AM
This is likely due to the default transfer mode for SIP on CUE. Try the following commands on the CUE module.
cue#conf t
cue(config)#ccn subsystem sip
cue(config-sip)#transfer-mode semi-attended
Hope this helps. If so, please rate the post.
Brandon
04-02-2008 11:26 PM
That command I'm executed before and now,it didn't help. Any other way to resolve this issue?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: