VG224 supported in UCM 6.0?

Unanswered Question
Apr 2nd, 2008

Trying to get a VG224 registered to UCM 6.0 but it is not registering. I noticed in the vg224 sccp setup, you can put a CCM version in there (but only up to 4.1). Is VG224 SCCP setup supported with UCM6.0?

I only need to fun analog phones off of this.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
matthewpage Wed, 04/02/2008 - 10:56

Im almost 100% sure that VG224 isnt supported in call manager 6.0 only Vg248 is supported.



matthewpage Wed, 04/02/2008 - 12:29

fair enought but i was fairly certain that the 6608 module and the vg224 were no longer supported. I will try get some confirmation.

Are you running 12.4T image?

Rob Huffman Wed, 04/02/2008 - 12:34

Hi Daniel,

I have worked with people who are successfully using the VG224 with CCM 6.0 so I don't think that is the issue :)

Here is a post from Adam;

I am not an expert with the VG224 as we are using all VG248's but there are some excellent config steps shown in this doc;

Hope this helps!


PS: I think the VG248's (like we are using :( are being phased out in favour of the VG224's.

matthewpage Wed, 04/02/2008 - 12:53

my bad it must have been the vg200 i was thinking about. Sorry about that.


Rob Huffman Wed, 04/02/2008 - 14:05

Hey Matt,

Every time I turn around one of the products we use is going EOL :) Who knows from day to day (I think we need to get on the EOL Mailer).

Take care,


UCcomp2007 Thu, 04/03/2008 - 03:32

Thanks Rob and everyone for your replies. I could not get VG224 when I setup as SCCP, so I switched it to MGCP. It registered right away.



This Discussion