04-04-2008 02:56 AM - edited 03-15-2019 09:51 AM
HI,
is it possible to use 2x 7914 with 7970 in CME 4.1 ?
The combination of 1x 7914 with 7970 works fine but the second one doesn't work.
kind regards
Mathias
04-04-2008 04:34 AM
Config ?
"debug tfpt event" trace ?
04-04-2008 07:48 AM
04-04-2008 08:50 AM
Config seems correct. Check that you will need an additional power brick for the 2nd sidecar.
04-05-2008 12:36 PM
Hi,
i have already connected 3 power supplies, one per 7970 and 2 for 7914.
The result: the second 7914 dosn`t work.
Best regards
04-05-2008 12:40 PM
I know it may sound obvious, check that 2nd sidecar rj11s in the IN connector.
Then swap the sidecar to exclude a faulty unit.
Does it flash the led when turning on ?
04-08-2008 12:51 AM
Hi Paolo,
the problem is solved. Indeed the 2nd 7914
had been connect to the Out connector. I
changed it to IN and it works.
Thank you for your help.
kind regards
Mathias
04-08-2008 01:26 AM
Glad to know it helped. Please remember to rate useful posts with the scrollbox below!
04-04-2008 06:13 AM
Hi Mathias,
Just one other question to add, did you change the setting shown below?
type phone-type [addon 1 module-type [2 module-type]]
Example:
Router(config-ephone)# type 7961 addon 1 7914 2 7914
There is a good reference in this doc;
Hope this helps!
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: