04-04-2008 05:38 AM - edited 03-15-2019 09:51 AM
Hi all,
after upgraded CUCME from versione 4.1 to 4.2 (i tested all release from 124-11.XW1 to 124-11.XW6 ipvoice), all calls through PSTN via ISDN E1-PRI don't work fine: all calls setup go fine, but customers that are calling hears metallic voice!
Here the E1 configuration:
!
isdn switch-type primary-net5
!
!
controller E1 0/0/0
clock source internal
pri-group timeslots 1-31
!
controller E1 0/0/1
clock source internal
pri-group timeslots 1-31
!
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn overlap-receiving T302 5000
isdn not-end-to-end 64
isdn incoming-voice voice
isdn map address .* plan unknown type unknown
isdn send-alerting
isdn sending-complete
!
interface Serial0/0/1:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn overlap-receiving T302 5000
isdn not-end-to-end 64
isdn incoming-voice voice
isdn map address .* plan unknown type unknown
isdn send-alerting
isdn sending-complete
!
!
voice-port 0/0/0:15
input gain 10
echo-cancel coverage 32
playout-delay nominal 100
playout-delay mode fixed
cptone IT
timeouts call-disconnect infinity
music-threshold -70
!
voice-port 0/0/1:15
input gain 10
echo-cancel coverage 32
playout-delay nominal 100
playout-delay mode fixed
cptone IT
timeouts call-disconnect infinity
music-threshold -70
!
!
!
i think that with new version i'm missing some configuration command (maybe in global config?)
Any idea?
P.S.: I need to integrate CUCME with CCX5.0
thanks for support
Solved! Go to Solution.
04-10-2008 10:54 AM
Just metallic or very distorted and not intelligible ?
Do you have the network-participate-commands and network-clock-select commands ?
Note: you don't need:
isdn not-end-to-end 64
isdn send-alerting
and none of the settings under voice port.
04-10-2008 10:33 AM
You may be hitting this bug:CSCsd90851
04-10-2008 11:01 AM
No, this bug has been fixed and does not apply.
04-10-2008 10:54 AM
Just metallic or very distorted and not intelligible ?
Do you have the network-participate-commands and network-clock-select commands ?
Note: you don't need:
isdn not-end-to-end 64
isdn send-alerting
and none of the settings under voice port.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: