Cisco 1200 Access Point Problems

Unanswered Question

We have a Cisco 1200 series access point, and we tried to do a firmware update. The update failed and the access does not seem to work now. The LEDs on the top blink in sequence: green, red, amber and it never stops. Resetting to factory defaults doesn;t seem to work. The firmware seems to be fine as all red LEDs are supposed to indicate an error with that. Any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Sat, 04/05/2008 - 07:33
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Console into the AP and post the log. This will help understand the issue better.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode