cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
256
Views
0
Helpful
1
Replies

Cisco 1200 Access Point Problems

iadlon
Level 1
Level 1

We have a Cisco 1200 series access point, and we tried to do a firmware update. The update failed and the access does not seem to work now. The LEDs on the top blink in sequence: green, red, amber and it never stops. Resetting to factory defaults doesn;t seem to work. The firmware seems to be fine as all red LEDs are supposed to indicate an error with that. Any suggestions?

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

Console into the AP and post the log. This will help understand the issue better.

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: