04-07-2008 03:41 AM - edited 03-03-2019 09:26 PM
I have two cisco router connected to each other by E1 connection ,also I implement a VPN between them (VPN over E1),one of these routers is connected also to the internet but when I tried to reach internet from the other router I could not>>I did a trace route from the router that is not connected to internet to real IP address but i could not reach(the default route on this router is toward the router connected to internet)
Any help??
04-07-2008 05:23 AM
You may have to post your config.
The NAT statement [if required] on the Internet facing router should include the source space behind the other router.
The VPN is for the inter-site communication or for all traffic?
Thanks.
04-07-2008 02:47 PM
forget about nating..trace route to real IP from the router that is not connected to internet was not successful????what you suggest
04-09-2008 07:09 PM
What does the traceroute show you, does the path try to go via the tunnel or via a default route?
04-09-2008 10:30 PM
the default route is through VPN Tunnel
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: