ok.

here is config...

regards..

As suspected, you are using PBR.

The solution is simple. Simply add another set statement within your current route-map pointing to F0/0 interface.

The route-map will try the destination in order. Currently you have:

set interface FastEthernet0/1

set ip next-hop 80.65.75.1

just modify it like:

set interface FastEthernet0/1

set ip next-hop 80.65.75.1

set interface FastEthernet0/0

HTH,

__

Edison.

ok

i will try this. hope it will resolve my problem.

thank you again...

i will post you the results.

regards

hello

i was did as you say

after re-configuring route map, it arrange line like this (little difference related to your post):

route-map zaCito permit 10

match ip address zaCito

set interface FastEthernet0/1 FastEthernet0/0

set ip next-hop 80.65.75.1

is this ok, or there are tricks how to do this...

regards

Interesting, the parser arranges the commands. Well, anyway - you have F0/1 before F0/0 so it should work. Have you test it ?

__

Edison.

yes, without success.

i was shoot down fa 0/1 and test it.

cant go out across other link.

i think i need another ip next hop, but how, it is internet packet with dynamic IP address...

ok

i will make nat and try again

will post you results

is this that:?

ip access-list extended G-nat

permit ip 172.16.3.0 0.0.0.255 any

permit ip 172.16.1.0 0.0.0.255 any

permit ip 172.16.4.0 0.0.0.255 any

deny ip any any

i got a result.

i was did exactly as You say:

route-map zaCito_rmp permit 10

match ip address zaCito_acl

set interface FastEthernet0/1 FastEthernet0/0

set ip next-hop 80.65.75.1 89.146.128.1

and i was add second ip next gateway.

Configure nat as You say and its work.

when shut fa 0/1 traffic go out through dialer

0.

NAT did as you say.

I thin that is it.

Thank You lot.

this is very helpful for me.

one more question:

will this config be ok...

route-map zaCito_rmp permit 10

match ip address zaCito_acl

set interface FastEthernet0/1

set ip next-hop 80.65.75.1

route-map zaCito_rmp permit 20

match ip address zaCito_acl

set interface FastEthernet0/0

set ip next-hop 89.146.128.1

regards

one more question:

will this config be ok...

route-map zaCito_rmp permit 10

match ip address zaCito_acl

set interface FastEthernet0/1

set ip next-hop 80.65.75.1

route-map zaCito_rmp permit 20

match ip address zaCito_acl

set interface FastEthernet0/0

set ip next-hop 89.146.128.1

Yes, nested route-map will work as well.

thanks again, a lot...

i did nested route-map.

its work fine, for now.

thank for your time.

best regards