04-07-2008 05:43 AM - edited 02-21-2020 01:58 AM
Hello,
I just checked one of our new ASA 5510 for the license that is configured on it. It shows a Security plus license but for some reason it shows 0 security contexts available (the device is just out of the box and is not configured yet) and there is no way to issue the command "mode multiple" either.
Looking at the Cisco documention I've seen that Security plus enables contexts....
Did anybody come across the same issue?
Regards.
04-11-2008 10:56 AM
ASA 5505 Security Plus License with Failover and Dual-ISP Backup : This configuration creates five VLANs: inside, outside, dmz, backup-isp and faillink
http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/examples.html#wp1038603
04-18-2008 06:07 AM
I believe you need to activate the license before the features are enabled. You should have received a PAK with the ASA. Usually it is a white envelope with a single sheet of paper in it. Go to http://www.cisco.com/go/license, enter the key there and you will receive a file via email that you upload to the ASA.
BTW ASA 5505 does not support contexts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: