04-07-2008 01:06 PM - edited 03-05-2019 10:14 PM
I have a Cisco Catalyst 5500 with a SupIII engine with a Dual Port 1000BaseSX Uplink Module (WS-U5534-GESX) and I'm connecting to an Extreme Networks device with an SX GBIC connector. and its not working.
2 questions.
1. What diameter does the Cisco uplink use 50 or 62.5 ? As I can not find it in any literature. I assume 62.5 as its around that time frame.
2. Since Cisco has a lot of proprietary stuff is there a standards issue keeping them from not connecting over the sx fiber link. If so is there a solution?
04-14-2008 04:53 AM
The UPlink port if connected with fiber optice cable then it uses the diameter of 62.5
04-14-2008 07:31 AM
Are you sure that the jumper is good and has the proper polarity? MM fiber with either of those 2 diameters should work.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: