WiSM Design Question

Unanswered Question

I have 2 WiSM's which I plan on placing in 2 geographically dispersed datacenters. I have 2 questions


1) Do I setup the 2 WLC's inside the WiSM to be in the same Mobility group to provide redundancy? Is that the best solution?


2) What is the best way to provide WiSM redundancy with this scenario? I will be supporting voice and data.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Scott Fella Tue, 04/08/2008 - 19:48
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Since this is for redundancy, all WLC will have to be on the same mobility group. Only if you you have different buildings would you might not want to have then on the same mobility group. For example... if WiSM 1 WLC 1 is primary for building 1 and WiSM 1 WLC 2 is primary for building 2 ,WiSM 2 WLC 1 is secondary for building 1 and WiSM 2 WLC 2 is secondary for building 2. Mobility group for WLC 1 would be building1 and WLC 2 would be building 2. If both WiSM's will be primary or secondary to any of the access points, will the mobility group name have to be the same.


The best redundancy, depends on your setup.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode