cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
14660
Views
0
Helpful
5
Replies

GigabitEthernet0/3 is down, line protocol is down (err-disabled)

djgizmo250
Level 1
Level 1

We had a 3560 go down today. It had an err-disable on its GigabitEthernet port.

This is a first. Do you guys have any clue as to why it would do this?

The 6513 FastEthernet stated that it was up/up.

I'm scratching my head for now...

Thanks!

5 Replies 5

mohammedmahmoud
Level 11
Level 11

Hi,

Please post the output of "show interface status err-disabled", it should have the reason, example:

Switch#show interfaces status err-disabled

Port Name Status Reason

Fa0/13 err-disabled bpduguard

BR,

Mohammed Mahmoud.

I already put the switch online by doing a shut/no shut on the port.

Here's the output of the show interface g0/3.

GigabitEthernet0/3 is down, line protocol is down (err-disabled)

Hardware is Gigabit Ethernet, address is 0013.1933.ef9b (bia 0013.1933.ef9b)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Auto-duplex, Auto-speed

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:59:19, output 00:59:19, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

178072502 packets input, 3914189599 bytes, 0 no buffer

Received 129108645 broadcasts (0 multicast)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 77596408 multicast, 0 pause input

0 input packets with dribble condition detected

35696681 packets output, 393726150 bytes, 0 underruns

Hi,

Without the output of "show interfaces status err-disabled" we can't say what was the reason of the err-disable, please issue it if this reoccurs.

BR,

Mohammed Mahmoud.

Will do. Thanks for the input.

I was in a panic mode and wanted to get the department back online ASAP.

If it occurs again, I'll be sure to issue the "show interfaces status err-disabled".

Thanks again!

Hi,

You are very welcomed, and good luck.

BR,

Mohammed Mahmoud.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card