Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
359
Views
0
Helpful
1
Replies

ap1200 constantly reboots after upgrading from Vxworks

planzone
Level 1
Level 1

‎04-08-2008 05:49 PM - edited ‎07-03-2021 03:41 PM

Hi I recently upgraded an ap 1200 series access point from the vxworks to ios. I noticr the ap just resets over and over repeatedly. I used the procedure on the site to upgrade with out retaining any settings. http://www.cisco.com/en/US/docs/wireless/access_point/conversion/ios/administration/guide/MT_AP_A.html#wp1007074

Reset ethernet port 0...

Reset done!

ethernet link up, 100 mbs, full-duplex

Ethernet port 0 initialized: link is up

Loading "flash:/c1200-k9w7-mx.122-11.JA3/c1200-k9w7-mx.122-11.JA3"...###########

###########################################

any hints or tips on how to resolve it from doing that?

Labels:
0 Helpful
1 Reply 1

drolemc
Level 6
Level 6

‎04-14-2008 05:54 AM

This looks like a corrupt firmware issue. Try using the mode button method on the AP to reload the firmware on the AP. The procedure is documented at

http://cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43trb.html#wp1038660

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card