cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
490
Views
5
Helpful
6
Replies

515 E UR 6x to 7x upgradation problem

CSCO10685316
Level 1
Level 1

After issuing the command copy tftp flash on the secondary PIX it is showing on the tftp server that transfer of the image completed. But on the session output of the pix is showing nothing like "image install". When try to reload the pix giving the error" copying the image can not reload".Please suggests on that. In this case if I power off /on the secondary pix what will be the effect whether the pix boot up with the old verson.

6 Replies 6

abinjola
Cisco Employee
Cisco Employee

do a sh flash..do you see new image installed ?

also check sh run | inc boot, the firewall will boot with the boot image you have set

No sh flash command is taken by the firewall.

No sh flash command is taken by the firewall.

okie..then you are on 6.x..reload the box and try again to upgrade form tftp..which mode of firewall is it ?

You mean to say power off/on. As the reload command is also not taking by the box.giving the error "can not relaod..writing emage"

mkkeyan
Level 1
Level 1

boot in Monitor mode , upgrade OS

thanks

karthik

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: