04-09-2008 12:39 PM - edited 07-03-2021 03:41 PM
I'm having a hard time setting up option 43. The standard command in nrcmd gives the following output.
nrcmd> vendor-option
322 Feature not supported - incompatible cluster version
nrcmd> vendor-option
322 Feature not supported - incompatible cluster version
nrcmd> help vendor-option
500 - cannot open help file /opt/nwreg2/local/docs/nrcmd/vendor-option.txt
It doesn't look like vendor-option even exists on this version. It looks like the command is now 'option'.
Anybody got any ideas.
04-10-2008 10:54 PM
You would normally add option 43 in the ip DHCP pool configuration, supply the rest of your DHCP config?
09-18-2008 05:28 AM
Did you figure this out?? I've got the same issue. Thanks!
03-22-2012 09:52 AM
Hi sdbrockme,
Try the command option-set rather than vendor-option, like the example below:
nrcmd> option-set aironet1200 create 8-bit vendor-option-string="Cisco AP c1200"
100 Ok
Regards,
Leandro Oliveira
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: