04-10-2008 08:18 PM - edited 03-03-2019 09:30 PM
Hi Guys!
Is there any way on how to decrease the delay time of a failover line when the other line turns down. Im using EIGRP for load balance and auto-failover.
Thanks!!!
04-10-2008 08:34 PM
Hi Chester,
With EIGRP, the failover is very fast, measured in milliseconds, especially when you have a feasible successor route in the topology table (like your situation).
Did you measure the failover time you have now ? What failover time would you like to achieve?
Cheers:
Istvan
04-10-2008 09:51 PM
The time the failover will come is may be around 6seconds. Can you give me a nice way on how to measure it? Im just trying to ping the LAN interface then i will manually shut the other WAN interface from the remote site. H.O site and Remote site are both having to MPLS connection terminated on two Serial Interfaces.
04-11-2008 06:21 AM
Hi Chester,
Can you please post your running-config and the output of the "show ip route" and "show ip eigrp topology" commands?
I would like to see what you have exactly there.
Thanks:
Istvan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide