04-11-2008 12:31 AM
Hi,
we have a cisco 2821 h323 voice gateway with an E1 interface, when we insert a new vic4fxs module the command related to the serial0/0/0:15 are not anymore accepted
****************
router1(config)#interface Serial0/0/0:15
^
% Invalid input detected at '^' marker.
****************
Router version: Version 12.4(13r)T
Any idea?
Thank you.
04-11-2008 01:55 AM
Likely you don't have enough dsp for bot E1 and 4 fxs, that requires 34 channels and you might have a pvdm2-32 only.
As a temporary workaround you can reduce the number of timeslots in pri-group.
Hope this helps, please rate post if it does!
04-11-2008 02:14 AM
The E1 use 30 or 32 channels?
In case are 30 if I use VIC2-2FXS would be accepted?
04-11-2008 09:52 AM
30 channels, but you can reduce this number to 28 with pri-group command under controller E1, and nothing bad will happen.
04-11-2008 10:02 AM
VIC4FSX/DID and VIC2-2FXS use the same number of resources
04-11-2008 12:28 PM
No, the four ports take 4 channels, and 2 ports takes two.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: